formestane

[bubblehead1428]

just doing some reading and was wondering if someone can help me figure out this transdermal formestane thing. how do you mix it, dose it, find it, find the carriers etc. thanks guys
pm me if nessecary

[llllern]

They sell Form on this site but no carrier so you will have to do a search google or do the PM thing :D

[GotTest]

Compliments of the wedge.:D
http://www.discountanabolics.com/forum/showthread.php?t=9998

[usf97j4x4]

I've done the math, the cost savings is not worth it to mix your own. I would just buy the premixed transdermal formestane. PM me or lllern and we can tell ya what to get.

I am running 80-100 mg/day along side my p-plex cycle, this is on the LOW end of the spectrum. If I was using it for PCT I would start at 200 mg/day and ramp down.

I am actually ramping it from like 100 down to 60, after a few days of 60 and I dont feel it as much then i go back to 100 and repeat. Seems to be working well.

I LOVE THIS STUFF

[llllern]

I have a beter 1 that he made up :)

Okay here was the process
1) Fill sink with hot water from the faucet. Place bottle in the water for 3-5 minutes to raise the temperature which facilitates saturation.
2) Unscrew bottle and pour 1/3 of the bag of formestane powder from the bag onto the center of a flat piece of paper in a DRY AREA.
3) Place a funnel on the top of the bottle. If you don't have a funnel, take a minute to make one with a piece of paper and some scotch tape. Worth it in my opinion.
4) Gently/easily pick up the paper by each side, gently tilt and then tape piece of folded paper until all of the powder has been transferred from the paper into the funnel.
5) Shake vigorously for around 1 minute.
6) Repeat steps 2-4 until all the powder is gone. Again - I poured the formestane in in three separate times.
7*) Fill sink with hot water again and place bottle in it for an additional 4-5 minutes.
8) Shake vigorously for another minute or so

Other tips:
*-You may place bottle in a water bath for a few minutes between addition of powder (repetition of step 1-3) for 2-5 minutes if you really would like to. I didn't, but if you're nervous go ahead and do so.
- Do this process carefully so you don't knock over the transdermal bottle or anything during the process. Just take your time - its not hard.

If you have the intelligence to bake a cake, you should be fine following that. Easy, peasy

[thebigt]

i am amazed when someone says they got nothing from td form. my only response is they didn't mix it right. i would suggest trying the pre-mixed first to see how you react, then if you want to make your own follow a good recipe like the one above. td form is real deal, enjoy.

[llllern]

I agree I tried both :) and like it

[Voodoo]

frankly i found with transdermals as long as its ground up and shook up in the solution before application youre fine.

[llllern]

frankly i found with transdermals as long as its ground up and shook up in the solution before application youre fine.

never had it NOT ground up ???


shake it vigorously for at least 30 prior to use

[thebigt]

frankly i found with transdermals as long as its ground up and shook up in the solution before application youre fine.

i agree with everything but formestane. it's the hardest one to get into solution, imo. if im mixing bulk powders i usually buy pre-mixed e-form and add the other to it.